Re: [PATCH 0/7] rockchip: Enable USB support for RK3528

Hi Jonas,

On 7/10/26 12:05 PM, Jonas Karlman wrote:
> This series picks USB related DT commits from v7.2-rc1-dts to enabled
> USB support on existing RK3528 boards. It also adds required DT nodes
> and enables required Kconfig options on the Generic RK3528 target.
> 
> The 'Add watchdog node for RK3528' commit was included to fully sync
> RK3528 DTs up to v7.2-rc1 state, it is not required for USB support.
> 

Yeah, I'm not sure this is necessary. If not applying it results in 
later imports conflicting due to different git context for example, then 
that's fine. Otherwise I don't think it brings anything. Here, I don't 
think the watchdog is in the git context for USB so it could have been 
ignored without any issue.

No need to respin for this. For the whole series:

Reviewed-by: Quentin Schulz <[email protected]>

Thanks!
Quentin