[PATCH v1 21/23] board: nbxv3: add operator commands and JTAG semihosting

Extend the u-boot prompt with few helpers:
 - CONFIG_CMD_DM, CONFIG_CMD_CACHE, CONFIG_CMD_WDT, CONFIG_CMD_GREPENV:
   driver model tree, cache control, watchdog control, environment grep.

 - CONFIG_SEMIHOSTING with CONFIG_SEMIHOSTING_FALLBACK: a module with a
   blank NOR is provisioned over JTAG (`load hostfs - <addr> <file>`
   from the debugger host, used by the provision_openocd_fit macro of
   the boot environment).

 - CONFIG_LAST_STAGE_INIT: the board hooks run on EVT_LAST_STAGE_INIT
   (already dispatched since DM_EVENT selects EVENT); make the intent
   explicit in the configuration.

Signed-off-by: Vincent Jardin <[email protected]>
---

 configs/nbxv3_tfa_defconfig | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/configs/nbxv3_tfa_defconfig b/configs/nbxv3_tfa_defconfig
index 554e0bf20ac..040353c4a03 100644
--- a/configs/nbxv3_tfa_defconfig
+++ b/configs/nbxv3_tfa_defconfig
@@ -28,21 +28,26 @@ CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_OF_STDOUT_VIA_ALIAS=y
 CONFIG_SYS_PBSIZE=532
+CONFIG_LAST_STAGE_INIT=y
 # CONFIG_ID_EEPROM is not set
 CONFIG_PCI_INIT_R=y
 CONFIG_RESET_PHY_R=y
 CONFIG_CMDLINE_PS_SUPPORT=y
 CONFIG_CMD_HISTORY=y
+CONFIG_CMD_GREPENV=y
 CONFIG_CMD_EEPROM=y
 CONFIG_SYS_I2C_EEPROM_ADDR_LEN=2
 CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=5
 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
+CONFIG_CMD_DM=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
 CONFIG_CMD_PCI=y
 CONFIG_CMD_SPI=y
 CONFIG_CMD_TEMPERATURE=y
 CONFIG_CMD_USB=y
+CONFIG_CMD_WDT=y
+CONFIG_CMD_CACHE=y
 CONFIG_CMD_RNG=y
 CONFIG_CMD_LOG=y
 CONFIG_OF_CONTROL=y
@@ -86,4 +91,5 @@ CONFIG_USB_XHCI_DWC3=y
 CONFIG_USB_MAX_CONTROLLER_COUNT=2
 CONFIG_WDT=y
 CONFIG_WDT_SBSA=y
+CONFIG_SEMIHOSTING=y
 CONFIG_ZSTD=y
-- 
2.43.0