Re: Introductions and help request.

Re: [breve] Introductions and help request.Thanks James (and Will),

I'd just written a matrix multiplication based method to do it, but this is obviously much neater (a quicker) - cheers.

Simon.
  ----- Original Message ----- 
  From: James Intriligator 
  To: [email protected] 
  Sent: Thursday, September 09, 2004 11:34 AM
  Subject: Re: [breve] Introductions and help request.


  ((Hi Simon - I was not allowed to post this to the list (it got bounced back) - so, I am sending it directly to you )).


------------------------------------------------------------------------------
  From: James Intriligator <[email protected]>
  Date: Thu, 09 Sep 2004 11:21:02 +0100
  To: <[email protected]>
  Subject: Re: [breve] Introductions and Vector Sub-components


    Hello Simon,
      Will Davis responded to a similar question on the mailing list a while back.
      His reply is at:  http://lists.spiderland.org/pipermail/breve/2004-May/000250.html
     
    here is the relevant excerpt.

      -james

    ===========================

    To get the individual vector components of vector v use the following:

    v::x gets you the x component, v::y gets you the y component and v::z 
    gets you the z component.

    Hope that helps,

    Will



  ------------------------------------------------
  James Intriligator, PhD
  Senior Lecturer

  School of Psychology - Experimental Consumer Psychology
  University of Wales - Bangor
  Brigantia Building - Room 328
  Bangor, Gwynedd LL57 2AS
  Wales, UK

  Tel: +44 (0)1248 383630
  Fax: +44 (0)1248 382599
  email: [email protected]
  ------------------------------------------------

_______________________________________________
breve mailing list
[email protected]
http://lists.spiderland.org/mailman/listinfo/breve