restarting simulation automatically?

Hi all,
Having found and used the end-simulation method, I'm wondering if there 
is some way to restart, re-init, reset, or the equivalent, rather than 
simply ending a simulation.  It would be nice to simply let it go for a 
long while, recording results or whatever as they happen.

BTW, I'm referring to the OS X GUI version of breve.  I suppose the 
command-line version could be more easily made to do this?

Thanks in advance,
Jim Grimes

___________________________________________________

Disclaimer:  Opinions stated herein are my own, and do not reflect 
policies or opinions of the Jet Propulsion Laboratory, NASA, or the 
California Institute of Technology.

James M Grimes                            Phone:  1-818-354-3890
Jet Propulsion Laboratory            Fax:       1-818-393-5239
Section 313 - Flight Systems       E-mail: [email protected]
Mailing  Address:                           Office Location: 301-475U
     Jet Propulsion Laboratory, M/S 301-486
     4800 Oak  Grove Drive
     PASADENA  CA 91109-8099

_______________________________________________
breve mailing list
[email protected]
http://lists.spiderland.org/mailman/listinfo/breve