Re: vectors in steve

On May 3, 2005, at 10:52 AM, Mithila Patwardhan wrote:

> Thanks - that works. I have a question about fixed joints. I have  
> two links with a fixed joint between them. If I move one link to a  
> specific location - I thought the other one (which doesn't have any  
> other links attached to it) should move automatically with it.  
> Would this happen only if I make a multibody out of them or is  
> there another way to go about it.

You'd either have to move them each individually, or move them  
physically by applying forces or accelerations.  "move" in breve is a  
non-physics based move -- it doesn't take other joints into account.

- jon klein
_______________________________________________
breve mailing list
[email protected]
http://lists.spiderland.org/mailman/listinfo/breve