Re: CommandByMail config

Hello Landon,

Yes it is the first line. Of the message and I did not use or

I will check the log to see. I am not familiar with mason cache but will google it to see how.

Thank you for the reply/info.

From: Landon Stewart [mailto:[email protected]]
Sent: Friday, October 28, 2016 12:30 PM
To: Dunbar, Brian
Cc: rt-users
Subject: Re: [rt-users] CommandByMail config

Is the command you are sending on the very first line of the message?  Did you really send an email with both of those commands with the word Or between them or was that two examples?  Is there anything in the log (ie. /opt/rt4/var/log/rt.log) when the email correspondence is being dealt with?  If you restarted apache did you clear the mason cache as well?

On Oct 28, 2016, at 6:38 AM, Dunbar, Brian <[email protected]<mailto:[email protected]>> wrote:

Hello All,

I am trying to enable CommandByMail

I installed the plugin and patch
Added these two lines to my RT_SiteConfig.pm
Plugin('RT::Extension::CommandByMail');
Set(@MailPlugins, qw(Auth::MailFrom Action::CommandByMail));

When I send an email with

Queue: Nameofqueue
Or
Status: resolved

It does not change any status info in RT
I am using RT 4.4.0
I did bounce the apache

Anyone with ideas?
---------
RT 4.4 and RTIR training sessions, and a new workshop day! https://bestpractical.com/training
* Los Angeles - Q1 2017

--
Landon Stewart
Lead Analyst - Abuse and Security Management
INTERNAP ®
📧 [email protected]<mailto:[email protected]>
🌍 www.internap.com<http://www.internap.com>

---------
RT 4.4 and RTIR training sessions, and a new workshop day! https://bestpractical.com/training
* Los Angeles - Q1 2017