Re: multiple elements in parallel

 I changed the transistor size to 40u(width) and 1u(length) from 200(width) and 5(length) with unit 200. The size displayed in the schematic became 0(width) and 0(length). Do I have to change the dimension of unit also? If so, will the schematic compatible with the backend(layout) in terms of drc and lvs?
 
 -SK Min
    
 -----Original Message-----
 From: [email protected]
 To: [email protected]
 Cc: [email protected]
 Sent: Wed, 27 Sep 2006 4:15 PM
 Subject: Re: multiple elements in parallel
 
  At 09:24 AM 9/27/2006, you wrote: 
 >Probably I was not good in explaining question No. 2. I was >asking whether real dimensions can be displayed in the schematic. >(Circuit designers, especially analog designers, are accustomed to >the real size of the devices in different processes. It gives direct >feel of the device performance.) If not directly, can it be done >when customized primitives are built? 
 
 Yes, if you put a "u" or other dimension notation at the end of a value, Electric understands it. 
 
 -Steven Rubin 
 
   
________________________________________________________________________
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.

_______________________________________________
Discuss-gnu-electric mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnu-electric