Re: Special characters and hyperlinks with target=_new

Hi Christian

You can try using DOCTYPE for using  , & etc. in your xsl.

And for opening in new window you can try target="_blank".

Regards
Sac

On Friday 21 May 2010 09:14 PM, Christian Merenda wrote:
> Thanks for the information. Can you pls drop me a line how to change 
> the serialiser statement back to HTML?
>
> Cheers
> Christian
>
> Hans Koerber schrieb:
>> Hi Christian,
>>
>> if I'm not wrong, both issues do boil down to validation.
>>
>> To get around 1) just use numeric values instead of HTML entities 
>> (e.g.   instead of $nbsp;)
>> In regards to 2), the target attribute is just not allowed in XHTML 
>> so you might have to switch back to HTML in your serialiser statement.
>>
>> Cheers,
>> Hans.
>>
>> Am Freitag, den 21.05.2010, 16:05 +0200 schrieb Christian Merenda:
>>> Hello,
>>>
>>> thanks for your replies so far. I will try your suggestions in the 
>>> evening.
>>>
>>> Just another two short questions:
>>>
>>> (1) I had problems with special characters in XSL files that I'm 
>>> used to in normal HTML, e.g.
>>>
>>>   or
>>> ©
>>>
>>> I'd like to use them in XSL and finally see them in the generated 
>>> HTML output. Can you tell me how I can achieve this with Lenya?
>>>
>>> (2) I wanted to add a hyperlink in an XSL file with...
>>>
>>> target="_new"
>>>
>>> ...to instruct the browser to open the linked website in another 
>>> tab/window. Unfortunately this seems to be impossible. Any suggestions?
>>>
>>> Thanks,
>>> Christian
>>>
>>> ---------------------------------------------------------------------
>>> To unsubscribe, e-mail: [email protected] 
>>> <mailto:[email protected]>
>>> For additional commands, e-mail: [email protected] 
>>> <mailto:[email protected]>
>>>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>