Re: Build Instructions?

Hi,

Thank you for your quick Response!

Some additional points:

Just as FYI, the reason I need to build it, instead of using .debs is
because I am using Debian/PowerPC.  I didn't check, but I assumed your
.deb files were for x86.

I am happy this project was open-sourced, of course, but I am curious as
to -why- the decision was made.

Also, if I can understand how the internationalization was done, I might
have time to localize it to Japanese.

thanks,
    noah silva

On Thu, 10 Jul 2003, Helge Hess wrote:

> I'll write detailed build instructions later in the evening, probably
> available tomorrow morning (MET).
>
> regards,
>    Helge
>
> Noah Silva [Mailing list] wrote:
> > Hi,
> >
> > I downloaded the source packages, but am not sure how they are to be
> > built.  I saw some dependency graph on the web site, but no instructions
> > on how to build the individial items.  Most don't have an autoconf script,
> > and make fails, apparently due to invalid paths.  I extracted all of the
> > .gz files, the only one I built properly was the build system itself.  Is
> > there some overview of how to make everything co-operate together?
> >
> > I am planning to possibly try to integrate some features of this software
> > with the recently released Qube sources if it is feasible.
> --
> http://www.opengroupware.org/
>
> --
> OpenGroupware.org Discussion [email protected]
> http://mail.opengroupware.org/mailman/listinfo/discuss
>