Re: getting distcc to compile without localhost

If your host is slow, try using pump mode;
that moves more of the work to the remote hosts.
In particular the preprocessing (cpp).
So you may get better performance with pump mode.
-- 
Fergus Henderson <[email protected]>

On May 29, 2009 2:21 AM, "Chris Robison" <[email protected]> wrote:

Actually I think I may be misinterpreting the log output.

I was noticing lots of lines like:
distcc[19451] cpp libxslt.c on localhost completed ok


...which led me to believe that some work was being done on localhost. But
then just now I noticed it's also dumping lines like:
distcc[19451] compile libxslt.c on 192.168.0.10/10 completed ok

Different line, same filename. So, I don't think I'll continue this thread
until I'm certain of what I'm seeing.  To do that I think I need to get the
monitor running correctly, but I'll start another thread for that.

Thanks,

 --chris

Martin Pool wrote: > > 2009/5/29 Chris Robison <[email protected]>: >
>> >> What is requi...

__ distcc mailing list            http://distcc.samba.org/ To unsubscribe or
change options: https:/...

__ 
distcc mailing list            http://distcc.samba.org/
To unsubscribe or change options: 
https://lists.samba.org/mailman/listinfo/distcc