Re: getting distcc to compile without localhost
Fergus Henderson <[email protected]>
| Newsgroups | gmane.comp.compilers.distcc |
|---|---|
| Message-ID | <[email protected]> |
If gentoo is still using the vintage distcc 2.x, then pump mode isn't supported - you would need to update gentoo to use distcc 3.x. -- Fergus Henderson <[email protected]> On May 29, 2009 9:46 AM, "Chris Robison" <[email protected]> wrote: Is there a way to get Gentoo portage to utilize pump mode? I've tried finding info online, but it's not in Gentoo's distcc doc and my google-mojo has failed me ... --chris Fergus Henderson wrote: > > > > If your host is slow, try using pump mode; > that moves more of the > work to the remote hosts. ... > Fergus Henderson <[email protected] <mailto:[email protected]>> > > >> On May 29, 2009 2:21 AM, "Chris Robison" <[email protected]<mailto: >> [email protected]>>... >> distcc[19451] compile libxslt.c on 192.168.0.10/10 < >> http://192.168.0.10/10> completed ok >> >> >> >> Different line, same filename. So, I don't think I'll continue this >> thread until I'm certain ... >> Martin Pool wrote: > > 2009/5/29 Chris Robison <[email protected]<mailto: >> [email protected]>>: > >> >> What is requi... >> >> >> >> __ distcc mailing list http://distcc.samba.org/ To >> unsubscribe or change options: ... >> > __ distcc mailing list http://distcc.samba.org/ To unsubscribe or change options: https://lists.samba.org/mailman/listinfo/distcc __ distcc mailing list http://distcc.samba.org/ To unsubscribe or change options: https://lists.samba.org/mailman/listinfo/distcc