IPv6 support in distccd?

Hi List,

I couldn't figure out how to use IPv6 addresses with the --allow option
of distccd. It is not documented at all. I don't want to use avahi
zeroconf option, just want to allow a single IPv6 IP address to
connect. I thought I ask on this list before diving into the source
codes.

Thanks in advance,

Misha.

-- 
Vanush "Misha" Paturyan
Senior Technical Officer
Computer Science Department
NUI Maynooth

__
distcc mailing list            http://distcc.samba.org/
To unsubscribe or change options:
https://lists.samba.org/mailman/listinfo/distcc

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2.0.16 (GNU/Linux)

iEYEARECAAYFAk3w91QACgkQyysGxoesgktT5gCgh8I8RT+KYbYW9TX61AyxeiA8
Pg0AoIiEdR374h0Ck0mHVarEplWPmGLV
=wC9+
-----END PGP SIGNATURE-----