Re: How to make all FPC utils?
Michael Van Canneyt via fpc-pascal <[email protected]>
| Newsgroups | gmane.comp.compilers.free-pascal.general |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 24 May 2025, Thomas Kurz via fpc-pascal wrote: >> Pass FPCMAKENEW=/path/to/utils/fpcm/bin/i386-win32/fpcmake.exe correct > the path to generated make. > > I must admit I don't understand this response. First thing is I'm on Linux x64 and I don't think that the `fpcmake.exe` will help. Apart from that, there *is* an fpcmake built just some minutes ago which is being used. > > My problem is just that I *can* `make` all utilities, but I have to > `chdir` into each separately. On the other hand, there is a makefile in > the parent directory which compiles lots of units, but just doesn't output > any binaries (except for some pas2js, iirc). Is this behavior > intentional? It is not intentional. If I run "make" in the utils/ directory, then all util programs are made. Michael. _______________________________________________ fpc-pascal maillist - [email protected] https://lists.freepascal.org/cgi-bin/mailman/listinfo/fpc-pascal