corbaloc discrepancy
"KRISHNAMURTHY, Sriram (Sriram)" <[email protected]> Fri, 5 Jun 2015 18:19:17 +0000
| Newsgroups | gmane.comp.corba.jacorb.devel |
|---|---|
| Message-ID | <F4700B2B84451240AFFBBBC19CB2D1A55CBDE48A@US70TWXCHMBA11.zam.alcatel-lucent.com> |
Hello I would like to know why i see the discrepancy between the PrintIOR utility and the CorbaLoc.generateCorbaloc method. The corbaloc URL below is for a EventChannel on a NotificationService. My setup is dual homed with two NIC and i am running jacorb 3.5 PrintIOR : corbaloc:iiop:[email protected]:13528,iiop:[email protected]:13528/6463423248/NotifyServicePOA/%01%073A@%026%06G%03$=%07%1F%1F*F$(%1F CorbaLoc.generateCorbaloc : iiop:[email protected]:13528/6463423248/NotifyServicePOA/%01%073A@%026%06G%03$=%07%1F%1F*F$(%1F Also, On a MutiHomed system can i play around with the iiop host section ? ie., if my corbaloc is corbaloc:iiop:[email protected]:13528,iiop:[email protected]:13528/6463423248/NotifyServicePOA/%01%073A@%026%06G%03$=%07%1F%1F*F$(%1F, would it be ok to manually remove the interfaces which are not reachable from the clients who would be using this IOR? which may be like corbaloc:iiop:[email protected]:13528/6463423248/NotifyServicePOA/%01%073A@%026%06G%03$=%07%1F%1F*F$(%1F Shouldn't it still work? Any insights would be very useful. Thanks Sriram _______________________________________________ jacorb-developer maillist - [email protected] https://lists.spline.inf.fu-berlin.de/mailman/listinfo/jacorb-developer