Re: omniORB4.1.6 installation problem
Duncan Grisby via omniORB-list <[email protected]>
| Newsgroups | gmane.comp.corba.omniorb.user |
|---|---|
| Message-ID | <[email protected]> |
On Mon, 2017-12-04 at 16:36 +0100, marcoconte_008--- via omniORB-list wrote: > building omniORB4.1.6 I faced an error: Why are you building such an old release? 4.1.6 was released in 2011. Ideally you should use 4.2.2, but if you really absolutely must have a 4.1.x release for binary compatibility with something ancient, at least use 4.1.7. That is only four years old, rather than six. > ../../../../../src/lib/omniORB/orbcore/corbaOrb.cc:631:42: error: > expected ‘)’ b > efore ‘OMNIORB_DIST_DATE’ > omniORB::logs(2, "Distribution date: " OMNIORB_DIST_DATE); What platform are you using? How did you configure omniORB for it? You need to give at least a little hint about your circumstances if anyone is going to stand any chance of helping you. Duncan. -- -- Duncan Grisby -- -- [email protected] -- -- http://www.grisby.org -- _______________________________________________ omniORB-list mailing list [email protected] http://www.omniorb-support.com/mailman/listinfo/omniorb-list