Re: Linking of ZIOPDynamic DLL fails under Windows with VS2017

Hi Duncan

Thanks for your reply!

I have to admit, that we do not actually use ZIOP (at least for now). I had enabled it out of curiosity.

Regards, Peter.


> -----Original Message-----
> From: Duncan Grisby [mailto:[email protected]]
> Sent: Thursday, April 26, 2018 4:38 PM
> To: Peter Klotz; [email protected]
> Subject: Re: [omniORB] Linking of ZIOPDynamic DLL fails under Windows
> with VS2017
> 
> On Thu, 2018-04-26 at 16:28 +0200, Peter Klotz via omniORB-list wrote:
> 
> > I have already sent the attached patch earlier but got no response
> > (and it was not integrated into upstream either). So I try again :-)
> 
> Yes, sorry, I did note your earlier email, and it's in the pile of
> changes that will be in 4.2.3, but I hadn't replied or checked it in
> yet.
> 
> I would recommend that you don't use the inconvenient standard way of
> initialising ZIOP that requires the omniZIPODynamic library anyway.
> 
> Duncan.
> 
> --
>  -- Duncan Grisby         --
>   -- [email protected]     --
>    -- http://www.grisby.org --

_______________________________________________
omniORB-list mailing list
[email protected]
http://www.omniorb-support.com/mailman/listinfo/omniorb-list