Re: Anybody seen a crash cleaning up thread specific storage like this?

Hello Jon, 

On Wed, Jan 04, 2006 at 09:04:46AM -0800, Jonathan Biggar wrote:
> Here's the gdb output from an application running OO 4.0.5 on Linux with 
> a 2.6 kernel:
> 
> #0  0x002557a2 in _dl_sysinfo_int80 () from /lib/ld-linux.so.2
> #1  0x002967d5 in raise () from /lib/tls/libc.so.6
> #2  0x00298149 in abort () from /lib/tls/libc.so.6
> #3  0x002ca27a in __libc_message () from /lib/tls/libc.so.6
> #4  0x002d0abf in _int_free () from /lib/tls/libc.so.6
> #5  0x002d0e3a in free () from /lib/tls/libc.so.6
> #6  0x00263a5d in ___tls_get_addr_internal () from /lib/ld-linux.so.2
> #7  0x0036bf7b in __libc_dl_error_tsd () from /lib/tls/libc.so.6
> #8  0x00261045 in _dl_catch_error () from /lib/ld-linux.so.2
> #9  0x0036bbce in __libc_dlsym () from /lib/tls/libc.so.6
> #10 0x004242f0 in _Unwind_ForcedUnwind () from /lib/tls/libpthread.so.0
> #11 0x00421f81 in __pthread_unwind () from /lib/tls/libpthread.so.0
> #12 0x0041df00 in pthread_exit () from /lib/tls/libpthread.so.0
> #13 0x082ef62b in omni_thread::exit ()
> #14 0x082eed86 in omni_thread_wrapper ()
> #15 0x0041d341 in start_thread () from /lib/tls/libpthread.so.0
> #16 0x00335fee in clone () from /lib/tls/libc.so.6
> 
> The application crashed with this message:
> 
>   *** glibc detected *** free(): invalid pointer: 0xb7f3db88
> 
> I saw this crash once or twice when running my application under VMWare, 
> but I finally saw it yesterday without virtualization.  I think it's 
> happening when the application is trying to exit, but it's hard to 
> capture much detail at that point.
> 
> -- 
> Jon Biggar
> Levanta
> [email protected]
> 

Did you mean to post this on the OmniORB mailing list rather than the
Orbacus mailing list?

Cheers,
Dave

-- 
David Weir                          
Team Orbacus - Your CORBA Source
E-Mail: [email protected]
WWW: http://www.orbacus.com
_______________________________________________
OB-Users Mailing List - [email protected]
http://mail.ooc.nf.ca/mailman/listinfo/ob-users
Visit our support FAQ before you send a message.
http://www.orbacus.com/faq/support.html