memory leak problem

Hi,
  In my corba program, I uses DSI and DII. At the same time, I write a=20
corba client and another corba service, which are used to test my program.
  In my test, I found that the memory which my program uses was always=20
rising very slowly, but after about 12 hours suddently rose up over 10M=20
bytes, and then began to rise very slowly. I have tested for more than 24=
=20
hours, the memory never descends.
  Other than only once large addition, the memory rises up 4k bytes or 16=
k=20
bytes every some hours. The memory rising speed is so little that I am no=
t=20
sure whether or not my program occurs memory leak. Please help me, Thank=20
you! By the way, I initializes my orb through the thread_pool model.

regards,
William

_________________________________________________________________
=C3=E2=B7=D1=CF=C2=D4=D8 MSN Explorer:   http://explorer.msn.com/lccn/ =20

_______________________________________________
OB-Users Mailing List - [email protected]
http://mail.ooc.nf.ca/mailman/listinfo/ob-users
Visit our support FAQ before you send a message.
http://www.orbacus.com/faq/support.html