servo_get_position(joint[0])

"David Weber" <[email protected]>
Newsgroups gmane.comp.cybernetics.webot.contest
Message-ID <002401c3a61b$3aeeeb50$0401a8c0@lapdw> 
hi all

i've got a problem with the servo_get_position(joint[i])-method:

when i want to get the actual angle of a joint of the robot i do that with 
e.g.      servo_get_position(joint[0])

but that always returns 0

any tips??

greetz david
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.