RE: Error: (-8033) on Log Backups

Hella John,

you're right that the error -8033 occurs only if autosave log
is enabled.

You can check the structure of the logbackups by using the command
	recover_check <medium> <type> <number>

Additionally you can check for several logbackups, whether the
values of "First LOG Page" and "Last LOG Page" - that you get as
a part of the result from recover_check - are ascending without any
gap between the logbackups.

Kind regards, Martin



> -----Original Message-----
> From: Cappellano, John J [mailto:[email protected]] 
> Sent: Wednesday, January 17, 2007 3:44 PM
> To: Brunzema, Martin
> Subject: RE: Error: (-8033) on Log Backups
> 
> Martin,
> If I turn off the auto log function and take log backup manually I do
> not see the 8033 error. How can I be certain the log backups 
> are okay if
> I keep auto log on? I would like to keep auto log set to on 
> for obvious
> reasons.
> 
> Please Advise
> 
> -----Original Message-----
> From: Brunzema, Martin [mailto:[email protected]] 
> Sent: Tuesday, January 16, 2007 4:57 AM
> To: [email protected]
> Cc: Cappellano, John J
> Subject: RE: Error: (-8033) on Log Backups
> 
> 
> 	From: Cappellano, John J
> [mailto:[email protected]] 
> 	Sent: Monday, January 15, 2007 9:03 PM
> 	To: [email protected]
> 	Subject: Error: (-8033) on Log Backups
> 	
> 	
> 	Hello All,
> 	I am getting the error -8033 every time a log backup (auto log
> on) executes. I looked up the error and it says:
> 	 
> 	
> 	-8033: Incomplete log segment Locate the document in the library
> structure
> <http://dev.mysql.com/doc/maxdb/en/bb/549e3dcf9a4c64e10000000a
> 114084/fra
> meset.htm> 
> 
> 
> 	Explanation:
> 
> 	You tried to save the log area. However, there are fewer log
> entries to be saved than defined in the general database parameter
> <http://dev.mysql.com/doc/maxdb/en/ef/eb3d408ae01e24e10000000a
> 1550b0/con
> tent.htm>  LOG_SEGMENT_SIZE.
> 
> 	User Action:
> 
> 	No action required
> 
> 	 
> 
> 	This has just recently started to happen. It does not appear to
> be an issue but I am not sure what is really happening. Any guidance
> would be appreciated.
> 
> Hello John,
> 
> this seems to be an error in writing the protocol. If you 
> look into the
> backuphistory and find
> directly above of the line which contains the error another 
> line with en
> errorcode 0 (say ok)
> and these two lines have the same data - then this error is fixed with
> newer builds:
> 	7.5.00.39
> 	7.6.01.09
> 	7.6.02.00
> 
> In this case the lines containing the errorcode -8033 does 
> not mean that
> there occured an error
> during autosave log.
> 
> Kind re
> 	
> 

-- 
MaxDB Discussion Mailing List
For list archives: http://lists.mysql.com/maxdb
To unsubscribe:    http://lists.mysql.com/[email protected]