RE: pop up pops under

Forget my last question.  It appears that your output panel is floating.  Look at Toad's main toolbar, do you see "default" in the dropdown?  Next to the dropdown, there should be a button dropdown, select that and choose "Restore default desktop"

From now on, your output window should open docked to the bottom of Toad

From: [email protected] [mailto:[email protected]] On Behalf Of Michael Moore
Sent: Thursday, October 06, 2011 3:14 PM
To: [email protected]
Subject: Re: [toad] pop up pops under



I think I know the problem.
When I choose Halt for debugger (the little hand icon), first the "Execution has Terminated" box pops up on top of the main toad window. Then, in the blink of an eye, the "Output" box pops up. This causes the main toad window to also come to the top which instantly covers the "Execution has Terminated" box.

I don't know why this "Output" box started popping up. It has two tabs, a "General"  tab and a "COM_APP@DMS1_DEV". I can't figure out how to make the "Output" box stop popping up.

Thanks,
Mike
On Thu, Oct 6, 2011 at 11:44 AM, Brad Boddicker <[email protected]<mailto:[email protected]>> wrote:

2 suggestions

1. You can turn off that "Execution has terminated" message in debugger options.
2. When this happens, open the task manager and select the toad application.  This sometimes will bring a stuck window to the front.

From: [email protected]<mailto:[email protected]> [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Michael Moore
Sent: Thursday, October 06, 2011 1:56 PM
To: Toad
Subject: [toad] pop up pops under



Sometimes the pop-up "Execution has terminated." for the debugger pops under the main window. When it does this, there is no way to click on it, nor is there a way to move the main window aside so that the pop-up is exposed.

This is not the only pop-up that does this. I suspect it has something to do with the fact that I use two monitors.

The only way I can bring the pop-up to the top is to go to the task manager and choose the "Switch To" button.

Is there a fix or workaround for this?

Mike