RE: Re: Toad v11 Schema browser LH tab order wrong - bug

This has been reported by Quest support and has been logged as a bug. It will likely be fixed in an upcoming beta.

From: [email protected] [mailto:[email protected]] On Behalf Of Boneist
Sent: Tuesday, October 11, 2011 9:29 AM
To: [email protected]
Subject: [toad] Re: Toad v11 Schema browser LH tab order wrong - bug [1 Attachment]


[Attachment(s) from Boneist included below]

Message from: Boneist


I've attached a picture that shows the order of the tabs when I first open the schema browser, and then what the Configure Browser Tabs is set to when I open it.

I haven't made any changes to the configuration, but when I click on "OK", the tabs shift to their correct positions.

My options are remembered, when I close Toad and reopen it again, they're just not applied.

Anyone? Bueller?

_______________________________________

Historical Messages


Author: Boneist
Date: Tue Oct 11 06:29:12 PDT 2011
I've attached a picture that shows the order of the tabs when I first open the schema browser, and then what the Configure Browser Tabs is set to when I open it.

I haven't made any changes to the configuration, but when I click on "OK", the tabs shift to their correct positions.

My options are remembered, when I close Toad and reopen it again, they're just not applied.

Anyone? Bueller?
__

Author: Boneist
Date: Tue Oct 11 06:23:28 PDT 2011

Am I the only one that's seeing this problem in v11?

It's really irritating having to "configure" the tabs everytime *{:-(
Message was edited by: Boneist
__

Author: Boneist
Date: Tue Oct 04 07:01:41 PDT 2011
Hi,

This is a minor, but fairly irritating bug in v11.

I've configured my schema browser to show the tabs (multi-lined) in the following order:

Tables
Views
Packages
Procedures
Functions
Triggers
....

However, when I first launch the schema browser (which is my default window to launch when I open a new session) the order is as follows:

Tables
Views
Procedures
Packages
Functions
Indexes
....

I right mouse click on the tab icon area and click configure, but the tabs are already listed in the right order. Clicking on ok then puts the tabs in the right order.

I've tried closing the schema browser with the tabs in the right order and relaunching it, but that comes back with the wrong order again. I've even closed Toad down entirely (making sure that the last schema browser closed had the tabs in the right order) and relaunching, only for the tabs to still show up in the wrong order.

Why are the settings not being applied when the schema browser is launched? Is it a bug, or is it something that I haven't got set right in the options?!

This worked fine in v10.6.

ETA: I've tried restoring the default order and then re-ordering and that didn't work - I still have the same issues with the ordering not taking effect until after I've opened up the config and clicked OK without amending anything. Message was edited by: Boneist
__
_______________________________________