RE: CodeXpert Tab

You can also right click in the editor -> Analyze for CA options.

From: [email protected] [mailto:[email protected]] On Behalf Of Brad Boddicker
Sent: Tuesday, November 08, 2011 01:47 PM
To: [email protected]
Subject: [toad] RE: CodeXpert Tab




> R-click in your editor toolbar and make sure the CA tab is visible.

What I meant to say was:

R-click in your editor toolbar and make sure the CA toolbar is visible.

From: [email protected] [mailto:[email protected]] On Behalf Of Brad Boddicker
Sent: Tuesday, November 08, 2011 1:46 PM
To: [email protected]
Subject: [toad] RE: CodeXpert Tab



Hi David,

The CodeXpert tab was removed and replaced with Code Analyst.  R-click in your editor toolbar and make sure the CA tab is visible.  Run your ruleset right there from the main toolbar and you will see a results tab open below.  You may have also noticed blue squiggly lines under some of your code, of so, these are CA violations and you can hover over or R-click on them to get more info about the rule violation.

Here is some more info and a demo:   http://www.youtube.com/watch?v=8MZ-FiZcExE



From: [email protected] [mailto:[email protected]] On Behalf Of Reed, David A.
Sent: Tuesday, November 08, 2011 1:24 PM
To: [email protected]
Subject: [toad] CodeXpert Tab


When I right click on the tabs underneath the editor, I can't select CodeXpert to get its tab displayed.  What setting am I missing?  I am using 11.0.0.116.

TIA,
Dave

David Reed
Principal Engineer
Integrated Systems Engineering and Process Improvement
Design Process Software
CWHQ2 318D

Westinghouse Electric Company
Suite 252
1000 Westinghouse Drive
Cranberry Township PA  16066, USA
Phone:  +1 (412) 374-6739
Fax:  +1 (412) 374-4575
Email:  [email protected]
Home Page:  www.westinghousenuclear.com