RE: Re: RE: CodeXpert Tab

[cid:[email protected]]

The first icon is send to CA.  The second icon will analyze code and give you the metrics in the editor.

From: [email protected] [mailto:[email protected]] On Behalf Of David Reed
Sent: Tuesday, November 08, 2011 02:54 PM
To: [email protected]
Subject: [toad] Re: RE: CodeXpert Tab





Message from: reedda


Brad: Bert needs to update his white paper "Engineering Better PL/SQL". I don't see a CA toolbar when I right click the editor toolbar. Right click gives me Edit, File. Execute, Current Schema, Desktop, Macro and Source Control. There is a "Send to Code Analysis" icon. YouTube is blocked here. Thanks, Dave

_______________________________________

Historical Messages


Author: David Reed
Date: Tue Nov 08 11:54:16 PST 2011
Brad: Bert needs to update his white paper "Engineering Better PL/SQL". I don't see a CA toolbar when I right click the editor toolbar. Right click gives me Edit, File. Execute, Current Schema, Desktop, Macro and Source Control. There is a "Send to Code Analysis" icon. YouTube is blocked here. Thanks, Dave
__

Author: Gregory Liss
Date: Tue Nov 08 10:48:32 PST 2011
You can also right click in the editor -> Analyze for CA options.
__

Author: Brad Boddicker
Date: Tue Nov 08 10:46:37 PST 2011
> R-click in your editor toolbar and make sure the CA tab is visible. What I meant to say was: R-click in your editor toolbar and make sure the CA toolbar is visible.
__

Author: Brad Boddicker
Date: Tue Nov 08 10:45:38 PST 2011
Hi David, The CodeXpert tab was removed and replaced with Code Analyst. R-click in your editor toolbar and make sure the CA tab is visible. Run your ruleset right there from the main toolbar and you will see a results tab open below. You may have also noticed blue squiggly lines under some of your code, of so, these are CA violations and you can hover over or R-click on them to get more info about the rule violation. Here is some more info and a demo: http://www.youtube.com/watch?v=8MZ-FiZcExE
__

Author: David Reed
Date: Tue Nov 08 10:23:53 PST 2011
When I right click on the tabs underneath the editor, I can't select CodeXpert to get its tab displayed. What setting am I missing? I am using 11.0.0.116. TIA, Dave David Reed Principal Engineer Integrated Systems Engineering and Process Improvement Design Process Software CWHQ2 318D Westinghouse Electric Company Suite 252 1000 Westinghouse Drive Cranberry Township PA 16066, USA Phone: +1 (412) 374-6739 Fax: +1 (412) 374-4575 Email: [email protected] Home Page: www.westinghousenuclear.com
__
_______________________________________