libpq connect keepalive* parms: no effect!?

I have searched fairly thoroughly and been unable to find a way to force 
prompt client application session breaks when PostgreSQL 
client-to-server transport fails.

I run a 7x24 PostgreSQL 9.1 "write-only" libpq client application 
(solely INSERTs/COPYs running on Debian 7 "wheezy" OS) that communicates 
with its PostgreSQL 9.0 DB server (Debian 6 "squeeze") via 
less-than-perfect intercontinental TCP Internet/VPN transport. The 
application has been running very reliably for over 4 years except for 
communication breaks.

Unfortunately, in this environment, connectivity lapses of a minute or 
two to an hour or two are common.  To minimize the risk of data loss 
when session recovery is attempted only AFTER the client queues data, I 
want to promptly detect and attempt recovery of lost sessions even when 
no transactions are pending.  To this end, I have tried:

#define PGSQL_KEEPALIVE_QSECS "60"
char pstring[6];
snprintf(pstring, sizeof(pstring), "%i", cnt0->conf.pgsql_port);
PQconnectdbParams(
   (const char *[]) {"dbname", "host",
     "user", "password", "port", "sslmode",
     "application_name", "connect_timeout", "keepalives",
     "keepalives_idle", "keepalives_interval", "keepalives_count", NULL},
   (const char *[]) {cnt0->conf.pgsql_db, cnt0->conf.pgsql_host,
     cnt0->conf.pgsql_user, cnt0->conf.pgsql_password, pstring, "disable",
     "motion", PGSQL_KEEPALIVE_QSECS, "1",
     PGSQL_KEEPALIVE_QSECS, PGSQL_KEEPALIVE_QSECS, "3", NULL}, 0))

As a baseline comparison, I establish a psql session with an all-default 
environment, break the VPN link, and then attempt a simple query (select 
count(*) from ...).  The query and psql session fail after about 17 
minutes' wait.  When testing the application -- even specifiying the 
above connection parameters -- I get approximately the same 17 minute 
timeout before a broken session is signalled at the application 
(PQconsumeInput(conn); if (PQstatus(conn)!=PGSQL_CONNECTION_OK) ...) 
when testing over the intentionally broken link.  This is a far cry from 
the maximum of 5 minutes I expected.

Based on postings elsewhere, I have also tried changing the relevant 
Linux kernel defaults of:

/proc/sys/net/ipv4/tcp_keepalive_time=7200
/proc/sys/net/ipv4/tcp_keepalive_probes=9
/proc/sys/net/ipv4/tcp_keepalive_intvl=75

to:

/proc/sys/net/ipv4/tcp_keepalive_time=60
/proc/sys/net/ipv4/tcp_keepalive_probes=3
/proc/sys/net/ipv4/tcp_keepalive_intvl=15

... with no detectable effect; still a ca. 17 minute timeout. (Failure 
of initial connection establishment IS  indicated rapidly; ca. 20 sec., 
with or without any of the above measures, even connection_timeout=60.)

Any ideas how to achieve the keepalives as specified in 
PQconnectdbParams when running on these platforms?

Thanks,
Bill Clay


-- 
Sent via pgsql-interfaces mailing list ([email protected])
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-interfaces