Re: Changing Pl/Python default interpreter

Hi Tom,

Thank you for your answer. Postgre's Ubuntu package is great, both Python 2
and 3 are supported out of the box. However, I would like to use virtual
environments instead of global install.

I have found a couple of solutions but none of them are really satisfactory:


   - Recompile Postgre from source with the PYTHON variable pointing to
   anaconda.
   - Activate virtualenv inside the default interpreter by using
   activate_this.py (https://gist.github.com/dmckeone/69334e2d8b27f586414a).
   - Set PYTHONPATH inside Postgre environment file (not compatible with
   Anaconda).


Regards,

Colin

On Sat, Dec 15, 2018 at 9:52 AM Colin Brisson <[email protected]> wrote:

> Hi Tom,
>
> Thank you for your answer. Postgre's Ubuntu package is great, both Python
> 2 and 3 are supported out of the box. However, I would like to use virtual
> environments instead of global install.
>
> I have found a couple of solutions but none of them are really
> satisfactory:
>
>
>    - Recompile Postgre from source with the PYTHON variable pointing to
>    anaconda.
>    - Activate virtualenv inside the default interpreter by using
>    activate_this.py (https://gist.github.com/dmckeone/69334e2d8b27f586414a
>    ).
>    - Set PYTHONPATH inside Postgre environment file (not compatible with
>    Anaconda).
>
>
> Regards,
>
> Colin
>
>
> On Fri, Dec 14, 2018 at 9:42 PM Tom Lane <[email protected]> wrote:
>
>> Colin Brisson <[email protected]> writes:
>> > I'm running PostgreSQL 10.6 (Ubuntu 10.6-0ubuntu0.18.10.1) with
>> Pl/Python.
>> > Everything is working fine but I would like to change the default
>> > interpreter used by Pl/Python (without recompiling Postgre from
>> scratch).
>> > The docs say that if the PYTHON environment variable wasn't set during
>> > compilation, Pl/Python use any version it found. I wrote a small script
>> and
>> > I found which interpreter Pl/Python is using by default. Now I would
>> like
>> > to modify the symlink it uses to run Python -- I'm just assuming it's a
>> > symlink but maybe I'm wrong. The problem is that I tried to modify all
>> > python executables in /usr/bin but it didn't change Pl/Python default
>> > behavior. Does anyone know where I can find which file Pl/Python use to
>> run
>> > Python? Is there a better approach to change the default interpreter?
>>
>> plpython loads the relevant libpython.so, it doesn't invoke the "python"
>> executable.  I do not think you can get it to use a different-version
>> libpython without recompiling.  It will *certainly* not work to sub in
>> python 3.x for python 2.x or vice versa without a recompile, if that's
>> what you were hoping for, because some of the library APIs changed.
>>
>>                         regards, tom lane
>>
>