Re: force re-planning of prepared statements?
Andrew McMillan <[email protected]> Wed, 31 Dec 2008 10:31:46 +1300
| Newsgroups | gmane.comp.db.postgresql.php |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 2008-12-30 at 07:34 -0800, [email protected] wrote: > > Hi Andrew, > > You are correct in assuming that there is some unexpected > selectivity. It hinges on the client id being used as the filter, > in this case, that id comprises only a very small fraction of the > table (448 rows out of 43352606). My question isn't really whether > or not the incorrect plan is being chosen, that part is pretty > obvious by looking at the plan, but more along the lines of what I > can do about it. > I'll try your suggestion about "PDO::Statementexecute" vs > "PDOStatement::bindParam()" and see if that makes a difference. If > not, I'll re-post on the pgsql-perf list. It seems to me that if PDO can *only* do prepared statements with positional/named parameters then that is a pretty serious bug. Potentially it can be fixed in the PostgreSQL driver, or in a wrapper layer, but there should really be a way of calling PDO::query with positional parameters as well, without the need for a prepare, as you can in DBI. I haven't used PDO myself yet, and was hoping to switch to it in a month or two, but I can imagine a lot of circumstances where this would be problematic. A couple of maybe helpful suggestions, from further reading the PDO documentation: - Perhaps PDO::BindValue gives a different effect (I wouldn't hold my breath though). - Perhaps a partial index on client id would solve your bad plan. CREATE INDEX client_id_partial ON client_whatsist(client_id) WHERE client_id > 0; Or something like that. Then in your query you can add a static part to the WHERE clause that says client_id > 0 AND ... so that gets picked as a high selectivity index. It's a complete hack, but it's about the most likely thing I can think of to work. In fact it may just be sufficient to add that in there. Of course equally you can put the " ... WHERE client_id = ".intval($client_id)." ..." into the statement directly, so the client ID is part of the preparation (or use PDO::quote if it isn't an intval, of course). Sometimes a bit of pragmatism is easier than tracking down the purist's solution. Regards, Andrew McMillan. ------------------------------------------------------------------------ andrew (AT) morphoss (DOT) com +64(272)DEBIAN Q: What's a WASP's idea of open-mindedness? A: Dating a Canadian. ------------------------------------------------------------------------ -- Sent via pgsql-php mailing list ([email protected]) To make changes to your subscription: http://www.postgresql.org/mailpref/pgsql-php