Re: [PORTS] Compile error: command not found

Peter,

Thanks for the promdt reply. I installed awk as per your suggestion,
and verified it's installation from the command line. But I am still
getting the exact same error shown below. Any other ideas?

On Fri, May 2, 2008 at 8:03 AM, Peter Eisentraut <[email protected]> wrote:
> Am Freitag, 2. Mai 2008 schrieb Nathan Garlington:
> > I downloaded 8.3.1 and ./configure and gmake went smoothly during the
> > installation process. But when I ran gmake install, I had these
> > errors:
> >
> > **********
> > gmake[3]: Entering directory `/root/postgresql-8.3.1/src/backend/utils'
> > AWK='' /bin/sh Gen_fmgrtab.sh ../../../src/include/catalog/pg_proc.h
> > Gen_fmgrtab.sh: line 84: $5 == "12" { print }: command not found
>
> Install awk?
>



-- 
Regards,
Nathan Garlington

-- 
Sent via pgsql-ports mailing list ([email protected])
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-ports