Re: ASCII codes in gprint

Bram <[email protected]> Thu, 21 Jan 2016 01:55:20 -0700 (MST)

Newsgroups	gmane.comp.db.rrdtool.user
Message-ID	<[email protected]>

I tried the above solutions, no luck.  A work-around does work for me:  use
'COMMENT' to place the degree symbol (alt-176).  Use '\g' to remove unwanted
spaces so that the degree C is placed close to the value.

      "GPRINT:PUL_MIN:minimum temperature\: %2.1lf\g" \
      COMMENT:"Â°C\n" \

I typed that without the 'carot A', it somehow got added.  I use the WinSCP
editor.

Bram



--
View this message in context: http://rrd-mailinglists.937164.n2.nabble.com/ASCII-codes-in-gprint-tp1074361p7583254.html
Sent from the RRDtool Users Mailinglist mailing list archive at Nabble.com.

_______________________________________________
rrd-users mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/rrd-users