RE: Recovering until a specific time

Hi,

which commands do you use and what release are you working with?

regards, Martin

> -----Original Message-----
> From: Daniel Blázquez [mailto:[email protected]] 
> Sent: Wednesday, August 27, 2003 12:11 PM
> To: [email protected]
> Subject: Recovering until a specific time
> 
> 
> Hi everybody,
> 
> i have been with SAPDB backup and recovery for a few days and i 
> havent been able to recover the state until a specific time.
> 
> i have tried with the DBM following the simple steps 
> (recovery-backup- restore last backup-restore database to a 
> specific time) but the logs 
> are always fully loaded (without stopping at required time). If i 
> reset the logs (whith util_execute INIT CONFIG) i return to the 
> status prior to las backup, according my expectations.
> 
> In DBMCLI mode, i can't obtain a session (with the command 
> util_connect).
> 
> ¿am i forgotting any step? ¿how can i return the status to a specific 
> time?
> 
> thank you in advance,
> daniel, spain.
> 
> _______________________________________________
> sapdb.general mailing list
> [email protected] 
> http://listserv.sap.com/mailman/listinfo/sapdb> .general
>