Re: Login failed
Frediano Ziglio <[email protected]>
| Newsgroups | gmane.comp.db.tds.freetds |
|---|---|
| Message-ID | <[email protected]> |
I noted you are using 0.82 version. It could occur that your version is not patched with post releases patches. Could you try 0.91rc1 ?? Frediano 2011/4/12 Robert Young <[email protected]>: > Yes > > -----Original Message----- > From: [email protected] [mailto:[email protected]] On Behalf Of Frediano Ziglio > Sent: April-12-11 4:17 AM > To: FreeTDS Development Group > Subject: Re: [freetds] Login failed > > Same user from error and dump ?? > > 2011/4/12 Robert Young <[email protected]>: >> Same result. >> >> -----Original Message----- >> From: [email protected] [mailto:[email protected]] On Behalf Of Frediano Ziglio >> Sent: April-12-11 3:28 AM >> To: FreeTDS Development Group >> Subject: Re: [freetds] Login failed >> >> Have you used DOMAIN\user syntax in -U argument ?? >> >> freddy77 >> >> 2011/4/12 Robert Young <[email protected]>: >>> I had already performed the telnet check. That was OK. I ran the tsql again >>> with a basic dump file (attached). >>> >>> -----Original Message----- >>> From: [email protected] >>> [mailto:[email protected]] On Behalf Of David Dick >>> Sent: April-11-11 5:55 PM >>> To: FreeTDS Development Group >>> Subject: Re: [freetds] Login failed >>> >>> On 11/04/11 23:56, Robert Young wrote: >>>> I've set up the latest version for 7.0 and the SQL Server is set up for >>>> Mixed Mode Authentication. I can log in to the SQL Server using my domain >>>> credentials but the following happens when I try to use tsql to connect: >>>> >>>> tsql -H myhost -p 1433 -U user >>>> >>> >>> Hi Robert, >>> >>> A couple of things you might find useful. >>> >>> 1) Try "telnet myhost 1433". If this command fails to connect, there is >>> nothing that freetds can do. You will need to talk to the administrator >>> of the machine and specifically enable tcp/ip communications for SQL Server. >>> >>> 2) If "telnet myhost 1433" does connect, see >>> http://www.freetds.org/userguide/logging.htm for how to set the TDSDUMP >>> environment variable and then run your tsql command again. The file >>> designated by TDSDUMP will contain a debug account of the connection. >>> If you wish to post this to the list for further analysis, beware that >>> the debug log will contain your username and password in clear and >>> encoded form. >>> >>> Cheers >>> David >>> >>> _______________________________________________ >>> FreeTDS mailing list >>> [email protected] >>> http://lists.ibiblio.org/mailman/listinfo/freetds >>> >>> _______________________________________________ >>> FreeTDS mailing list >>> [email protected] >>> http://lists.ibiblio.org/mailman/listinfo/freetds >>> >>> >> _______________________________________________ >> FreeTDS mailing list >> [email protected] >> http://lists.ibiblio.org/mailman/listinfo/freetds >> >> >> _______________________________________________ >> FreeTDS mailing list >> [email protected] >> http://lists.ibiblio.org/mailman/listinfo/freetds >> > _______________________________________________ > FreeTDS mailing list > [email protected] > http://lists.ibiblio.org/mailman/listinfo/freetds > > > _______________________________________________ > FreeTDS mailing list > [email protected] > http://lists.ibiblio.org/mailman/listinfo/freetds > _______________________________________________ FreeTDS mailing list [email protected] http://lists.ibiblio.org/mailman/listinfo/freetds