Re: Trouble With Configure and Make on HP-UX 11.31 ia64
Wes Crews <[email protected]>
| Newsgroups | gmane.comp.db.tds.freetds |
|---|---|
| Message-ID | <48E853FCA52BE24AAC06BD65F33543F835159A49@mbx027-w1-ca-6.exch027.domain.local> |
The first error I sent was when the CPFLAGS and CFLAGS variables were set to "+DD32". I tried again with them set to "+DD64" and the error was as follows: ld: Mismatched ABI for -lxnet, found /usr/lib/hpux32/libxnet.so Fatal error. *** Error exit code 1 Stop. *** Error exit code 1 Stop. *** Error exit code 1 Stop. *** Error exit code 1 Wes Wesley Crews Senior Information Consultant NexLevel Information Technology Phone: 310-977-3609 http://www.nexlevelit.com mailto:[email protected] ********************************************************************************************************************************************************* This message and accompanying documents are covered by the Electronic Communications Privacy Act, 18 U.S.C. §§ 2510-2521, and contain information intended for the specified individual(s) only. This information is confidential. If you are not the intended recipient or an agent responsible for delivering it to the intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination, copying, or the taking of any action based on the contents of this information is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail, and delete the original message. ********************************************************************************************************************************************************* -----Original Message----- From: Wes Crews Sent: Wednesday, June 12, 2013 5:27 PM To: [email protected] Subject: RE: [freetds] Trouble With Configure and Make on HP-UX 11.31 ia64 Thanks for the quick reply. The full error I am getting is: ld: Unknown input file type: "../../dblib/.libs/libsybdb.so" Fatal error. *** Error exit code 1 Stop. *** Error exit code 1 Stop. *** Error exit code 1 Stop. *** Error exit code 1 Wes Wesley Crews Senior Information Consultant NexLevel Information Technology Phone: 310-977-3609 http://www.nexlevelit.com mailto:[email protected] ********************************************************************************************************************************************************* This message and accompanying documents are covered by the Electronic Communications Privacy Act, 18 U.S.C. §§ 2510-2521, and contain information intended for the specified individual(s) only. This information is confidential. If you are not the intended recipient or an agent responsible for delivering it to the intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination, copying, or the taking of any action based on the contents of this information is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail, and delete the original message. ********************************************************************************************************************************************************* -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of James K. Lowden Sent: Wednesday, June 12, 2013 5:19 PM To: [email protected] Subject: Re: [freetds] Trouble With Configure and Make on HP-UX 11.31 ia64 On Wed, 12 Jun 2013 17:19:34 +0000 Wes Crews <[email protected]> wrote: > am running into issues with the configuration and make files. If > anyone has had luck with getting freeTDS built and deployed on HP-UX > 11.31 ia64 I would appreciate some pointers for getting it done. Should just be $ mkdir build $ cd build && ../configure $ make && make install What is the complete command line of the failed compile/link command, and what is the error message? --jkl _______________________________________________ FreeTDS mailing list [email protected] http://lists.ibiblio.org/mailman/listinfo/freetds