Re: [U2] JET Command parameters

Hmmm. Since the output is going to the spooler, then being exported and being printed
>From another application. Looks like the J and the Q really aren't needed (for this application)

Thanks
George

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Bruce Decker
Sent: Tuesday, January 07, 2014 2:36 PM
To: U2 Users List
Subject: Re: [U2] JET Command parameters

J= Printer driver.  For printers that use table-drive printer drivers 
such as the HP laserJet to activate letter quality features.
Q=Quality (letter quality)
P=Print to spooler


On 1/7/2014 12:23 PM, George Gallen wrote:
> OK.
>
> I'm looking at Paragraph that runs "JET-OUT" and passes (J,Q,P)
>
> What do the J, Q and P signify?
>
> J=justified?
> Q=quiet?
> P=to the printer?
> George Gallen
> Senior Programmer/Analyst
> Accounting/Data Division, EDI Administrator
> [email protected]
> ph:856.848.9005 Ext 220
> The Wyanoke Group
> http://www.wyanokegroup.com<http://www.wyanokegroup.com/>
>
> _______________________________________________
> U2-Users mailing list
> [email protected]
> http://listserver.u2ug.org/mailman/listinfo/u2-users

_______________________________________________
U2-Users mailing list
[email protected]
http://listserver.u2ug.org/mailman/listinfo/u2-users
_______________________________________________
U2-Users mailing list
[email protected]
http://listserver.u2ug.org/mailman/listinfo/u2-users