Re: Cross-compilation problem
Mazi Lo <[email protected]>
| Newsgroups | gmane.comp.db.unixodbc.devel |
|---|---|
| Message-ID | <[email protected]> |
Nick, The compilation always crashes on the same spot. I doubt it is a hardware issue. The reason is my system is able to cross compile the whole OpenWRT firmware for many different platforms. It may be a compiler issue. However, I woulr rather think it is not. That's why I sent this to the mailing list and see if unixodbc developers can find out what causes the issue. -- Mazilo Date: Sun, 19 Jun 2011 16:28:06 +0100 From: [email protected] To: [email protected] Subject: Re: [unixODBC-dev] Cross-compilation problem On 19/06/2011 14:16, Mazi Lo wrote: For the past few months, I have unsucessfully tried to cross compile unixodbc (from the latest SVN trunk) as shown below. If I reissued make after the compilation crashed, the compilation went smoothly to produce a usable package. So, in this case, I will need to issue a 2x compilations in order to produce a useable binary package and that is of course making no sense. I am hoping developers here can help to solve this issue. BTW, I am using the latest revision #35 of unixodbc from SVN trunk. Thank you. If the compiler crashes, and then works ok, it may be a hardware problem at your side. Does it always crash in the same place, Do you have a copy of the output when it crashed? -- Nick _______________________________________________ unixODBC-dev mailing list [email protected] http://mailman.unixodbc.org/mailman/listinfo/unixodbc-dev _______________________________________________ unixODBC-dev mailing list [email protected] http://mailman.unixodbc.org/mailman/listinfo/unixodbc-dev