Re: Build failure on MinGW

On 11/11/2010 02:21 PM, Clemens Valens wrote:
> I managed to get a bit further by putting my TCL/TK build results in
> the MinGW\msys\1.0\lib (.a&  .sh) and MinGW\msys\1.0\bin (dll&  exe)
> folders. Now I have this error:

Here is finally some good news... I have just built/installed/run 
insight -- using ONLY sourceware-supplied sources (i.e., no ActiveState 
Tcl necessary) on mingw w/msys!

There are a few little problems, and I hope to have patches for those 
committed in the next day or two. Mind you, I also haven't tested it 
exhaustively -- just stepped through gdb with register, console, locals, 
stack, breakpoints windows open. Just a sanity check.

Keith

PS. Do you want to pursue your current course w/ActiveState tcl? If so, 
I'll need to see the configure/build logs...