Re: source window is blank

Tom Hughes <[email protected]> Mon, 14 Jun 2004 14:42:32 +0100

Newsgroups	gmane.comp.debugging.ups.user
Organization	Cyberscience Corporation
Message-ID	<[email protected]>

In message <[email protected]>
        choube mehul <[email protected]> wrote:

>     i downloaded ups-3.37.tar.gz.
>     i compiled and installed ups on linux.
>     Red Hat Linux release 9 (Shrike)
>     Kernel 2.4.20-8 on an i686
>
>     i am not able to see source code in source window.

You did compile your program with -g I assume?

>     i tried with Add Path.

You shouldn't need to do that if you're using gcc.

Tom

-- 
Tom Hughes ([email protected])
Software Engineer, Cyberscience Corporation
http://www.cyberscience.com/