Releasing Breakpoints from ups

Hi..
 
      I ran into a small problem with the upsv3.33 solaris build of the debugger
 
      I was debugging a program and the ups core dumped. But the process looked like it was still running 
      ( "truss"ing the process showed me it was still active ). But when the break point was hit, the process core dumped too.
      So I was wondering, if there was any way I can release the break point from the process externally. 
      Pardon me if this question is totally out of the world, Cos I dont have an indepth knowledge of how a debugger works.
      I would really appreciate it, if I can get an answer of some sort, Please reply to [email protected] <mailto:[email protected]> .
 
     Thanx 
 
Shanker


DISCLAIMER 
This e-mail, and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail, you are hereby notified that any dissemination, distribution or copying of
this e-mail, and any attachments thereto, is strictly prohibited. If you have received this e-mail in error, please immediately notify me and permanently delete the original and any copy of any e-mail and any printout thereof. 
E-mail transmission cannot be guaranteed to be secure or error-free.  The sender therefore does not accept liability for any errors or omissions in the contents of this message which arise as a result of e-mail transmission. 
NOTICE REGARDING PRIVACY AND CONFIDENTIALITY 
Knight Trading Group may, at its discretion, monitor and review the content of all e-mail communications.