Re: How do I use GNU AutoTools?

Thanks. I've looked at meson's website and it looks amazing. I'm mostly
just glad I won't have to use autotools.

On Mon, Jul 11, 2022 at 11:21 AM Mailing Lists <[email protected]>
wrote:

> +1 for Meson, these other build systems are a bit tedious (especially
> comparatively)!
>
>
> Sent from Proton Mail mobile
>
>
>
> -------- Original Message --------
> On Jul 11, 2022, 8:11 AM, Alexander Schwinn < [email protected]> wrote:
>
>
> If you anyhow want to start from scratch, I would suggest using meson.
>
> cmake imo is just a different hell / not any better than autotools,
>
> Cheers, Alex
>
> Am 11. Juli 2022 14:11:43 MESZ schrieb samuel ammonius <
> [email protected]>:
>>
>> Hi. I hope this isn't too off-topic, but I came from this forum thread
>> <https://forum.xfce.org/viewtopic.php?pid=67991#p67991> hoping to find
>> out how to use autotools for a fork of XFCE that I was hoping to make. I
>> have a few questions:
>>
>>    1. Is it ok if I just use CMake or is there a reason that XFCE uses
>>    autotools (is the reason just that CMake wasn't available when XFCE was
>>    created?)
>>    2. If CMake is a bad option, how do I actually use autotools?
>>
>> _______________________________________________
> Xfce4-dev mailing list
> [email protected]
> https://mail.xfce.org/mailman/listinfo/xfce4-dev
>
>

_______________________________________________
Xfce4-dev mailing list
[email protected]
https://mail.xfce.org/mailman/listinfo/xfce4-dev