[Bug 1945] clipman crashes noisily when I copy binary junk

Do NOT reply to this email.  To make further comments on this bug, use
the URL below:
http://bugzilla.xfce.org/show_bug.cgi?id=1945





------- Comment #4 from [email protected]  2006-06-21 21:05 UTC -------
I tried that version but still get the same problem.

I made a 1-byte file containing just character 0300 (octal), copied that using
Emacs, and clipman started printing it's error message over and over again.

I don't know how to run clipman so that I can see its output other than by
running xfce4 inside a FreeNX session.  Is there another way, so that I can run
FreeNX out of the equation?  ~/.xsession-errors has "...Too much output,
ignoring rest..." at the end of it, so I can't watch that.  Is there some way
of invoking clipman from the command line and getting it to run properly?


-- 
Configure bugmail: http://bugzilla.xfce.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.