Re: xfce4-hwsensors-plugin

Am Mittwoch, den 27.07.2005, 00:29 +0200 schrieb Stefan Ott:
> Hi
> 
> On Tue, Jul 26, 2005 at 05:12:40PM +0200, Fabian Nowak wrote:
> 
> > actually, looking at the "next generation", i can't imagine that the
> > changes were so huge. thus, regarding the display, 
> 
> > i just think that adding a checkbox or radio button menu "display
> > graphically" <--> "display numerically" whould be the only difference in
> > the UI; internally this switch could handle everything.
> 
> well, we could try to implement that.

so it's up to you, you have the changes ;)

but i'm not quite sure, if one tooltip for the whole plugin wouldn't be
better...

> 
> > besides, why didn't you use version 0.5.0 to apply your changes?
> 
> because 0.3.0 was the latest one i could find on
> http://developer.berlios.de/project/showfiles.php?group_id=910. where
> can i get a copy of version 0.5.0?

actually, by svn or try
http://mitglied.lycos.de/timshome/download/xfce4-sensors-plugin-0.5.0.tar.gz or  http://mitglied.lycos.de/timshome/download/xfce4-sensors-plugin-0.5.0.tar.bz2
> 
> > as a further note: both my two temperature sensors with 45°C and 32°C
> > had no green bar...
> 
> did you set a reasonable maximum? the default is 7000, so you probably
> won't see anything for a value of 45...

aehm, i didn't set anything because i'm not used to setting many values
in Xfce ;)
the 0.5.0 code contains some trivial checks for sensor values and tries
to classify temperature, speed i.e. rpm, voltage. this could be used to
automatically find maximum values, like 70°C for temp, 5000rpm for fans,
and perhaps 13V for valotages, 7000 for any other.

> 
> regards

bye, fabian