Re: Client for FPGA

Pretty cool. what about FTDI company? they seem to be
recommended quite a bit.
Do you have schematics for the board, and drivers?
FTDI advertises a development board with an Altera
device with 10K equiv gates. Probably need something a
little bit bigger.
Some day I will actually start making the calculations
how many gates are needed.

david
--- jbass-/[email protected] wrote:

> Elektron <elektron_rc5-FFYn/[email protected]>
> > USB support is possible too, but it'll be harder
> to implement on an 
> > FPGA.
> 
> Been there ... done that :)  ... was a 3 hour design
> to include on two
> FPGA boards here.
> 
> Piece of cake using FT2232, or the earlier fifo
> chips in bit bang mode.
> Use A channel as a JTAG port, and interface the B
> channel in fifo mode
> to FPGA data pins.
> 
> John
> _______________________________________________
> Hardware mailing list
> Hardware-Ra3b/QYEcJ3d140v2zMXi0fjHoOT/h/[email protected]
>
http://lists.distributed.net/mailman/listinfo/hardware
> 

_______________________________________________
Hardware mailing list
Hardware-Ra3b/QYEcJ3d140v2zMXi0fjHoOT/h/[email protected]
http://lists.distributed.net/mailman/listinfo/hardware