Re: Client for FPGA

FT2232 is FTDI's latest chip ... doc and sample design on
their web site.

John

	Pretty cool. what about FTDI company? they seem to be
	recommended quite a bit.
	Do you have schematics for the board, and drivers?
	FTDI advertises a development board with an Altera
	device with 10K equiv gates. Probably need something a
	little bit bigger.
	Some day I will actually start making the calculations
	how many gates are needed.

	david
	--- jbass-/[email protected] wrote:

	> Elektron <elektron_rc5-FFYn/[email protected]>
	> > USB support is possible too, but it'll be harder
	> to implement on an 
	> > FPGA.
	> 
	> Been there ... done that :)  ... was a 3 hour design
	> to include on two
	> FPGA boards here.
	> 
	> Piece of cake using FT2232, or the earlier fifo
	> chips in bit bang mode.
	> Use A channel as a JTAG port, and interface the B
	> channel in fifo mode
	> to FPGA data pins.
	> 
	> John
	> _______________________________________________
	> Hardware mailing list
	> Hardware-Ra3b/QYEcJ3d140v2zMXi0fjHoOT/h/[email protected]
	>
	http://lists.distributed.net/mailman/listinfo/hardware
	> 

	_______________________________________________
	Hardware mailing list
	Hardware-Ra3b/QYEcJ3d140v2zMXi0fjHoOT/h/[email protected]
	http://lists.distributed.net/mailman/listinfo/hardware

_______________________________________________
Hardware mailing list
Hardware-Ra3b/QYEcJ3d140v2zMXi0fjHoOT/h/[email protected]
http://lists.distributed.net/mailman/listinfo/hardware