Re: Fully unrolled RC5 on FPGA
"John L. Bass" <jbass-/[email protected]> Mon, 13 Nov 2006 12:07:22 -0700
| Newsgroups | gmane.comp.distributed-net.hardware |
|---|---|
| Message-ID | <[email protected]> |
Nobody even said they want to tackle the job of designing a board. -- Martin K Actually I voluteered to provide significant help ... starter layout with 3.3V pci form factor. Group effort to evolve the design, design check, and reach concensus for a group effort. I can do fab in my lab for short runs (<20 pieces) ... bigger than that it can be handed to a contract mfg shop for batch builds. CM fees are probably around $50-100/board for assembly. John _______________________________________________ Hardware mailing list Hardware-Ra3b/QYEcJ3d140v2zMXi0fjHoOT/h/[email protected] http://lists.distributed.net/mailman/listinfo/hardware