Odd error after install.

Greetings,

	I was setting up public file on a new firewall box and got some odd
behavior after installation.

	daemontools and publicfile both installed correctly according to the
logs, however, I am getting the following error message when the service is
trying to start publicfile.

softlimit: fatal: unable to run tcpserver: file does not exist

This is running on an OpenBSD 3.8 release build. daemontools was installed
from the Ports tree included on the CD. Publicfile installed from downloaded
package.

So where should I poke first? This is the first time I've had this error on
countless installs of public file. (I like public file since all the box
need to host is traffic data produced by pfstat.

	--David Chubb

System Integration & Support Representative 
==========================
8603 Westwood Center Drive
Suite 250
Vienna, VA 22182
Phone: 703-734-1133x102
E-mail: [email protected]
==========================