Re: creating new frames using theodore for applets (dialogs)?
"Wolf Paulus" <[email protected]>
| Newsgroups | gmane.comp.embedded.carlsbad-cubes |
|---|---|
| Message-ID | <[email protected]> |
David,
Take a look at Theodore's Project menu and open the Settings dialog.
Besides other project related settings, this dialog allows the selection
of a standard panel-based or dialog-based project.
Regards
Wolf Paulus
--
Wolf Paulus
C a r l s b a d C u b e s
mailto:[email protected]
CONFIDENTIALITY NOTICE:
This message is intended only for the use of the individual or entity to
which it is addressed, and may contain information that is privileged,
confidential and exempt from disclosure under applicable law.
If you are not the intended recipient, please contact the sender by reply
email and destroy all copies of the original message.
----- Original Message -----
From: "David Kafrissen" <[email protected]>
To: <[email protected]>
Sent: Tuesday, November 25, 2003 9:19 AM
Subject: [Forum] creating new frames using theodore for applets (dialogs)?
> Greetings,
>
> Is there a way to create new windows from applets using Theodore?
>
> I am investigating Theodore. It looks like an exciting approach but I do
not
> see dialogs in the list of widgets. In the thinlets samples there are xml
> code that shows the dialog widget that does load into the Theodore editor
> but this editor does not show it in the list as a choice to create a new
> one, only if it already exists.
>
> Any thougts?
>
> Thanks in advance,
>
> Dave
>
> _______________________________________________
> Forum mailing list
> [email protected]
> http://carlsbadcubes.com/mailman/listinfo/forum_carlsbadcubes.com
>
>