Re: EDX value after reset

Yes, it is correct. 

I don’t see any reason to invent any values of BIST test which Bochs doesn’t perform.

 

Thanks,

Stanislav

 

From: Henk Nep [mailto:[email protected]] 
Sent: Tuesday, March 28, 2017 1:02 PM
To: [email protected]
Subject: [Bochs-developers] EDX value after reset

 

Hi All,

I just compiled 2.6.8 and noticed that the EDX register no longer contains the self test value after reset, is this correct?

       P6          Pentium     486
EDX    000006xxH   000005xxH   000004xxH 

The value after reset is 0. Here is my .conf file:

./configure --target=pentium-windows \
            --enable-sb16 \
            --enable-ne2000 \
            --enable-all-optimizations \
            --enable-cpu-level=4 \
            --disable-fpu \
            --enable-pci \
            --enable-x86-debugger \
            --enable-debugger \
            --enable-iodebug \
            --enable-clgd54xx \
            --enable-show-ips \
            --disable-readline \
            --without-x \
            --with-win32 --with-rfb --with-nogui

Many thanks.

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
bochs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bochs-developers