Re: Hercules networking problem...again
| Newsgroups | gmane.comp.emulators.hercules390.general |
|---|---|
| Message-ID | <[email protected]> |
Dear Brian,
I waned to contact you via private mail ( if that would have been appropriate ), however, I couldn't find a way to do so. So I will write here, with the risk of antagonizing some of our colleagues ( for good reason I am sure ) .
I have managed to define and start resolver as a STC, and copied all required parameters from TCPIP.SEZAINST dataset ( the default ones.. ). Here is the startup on the console :
00- 08.11.46 STC00838 $HASP373 RESOLVER STARTED
08.11.46 STC00838 EZZ9298I DEFAULTTCPIPDATA -
ADCD.Z113S.TCPPARMS(TCPDATA)
08.11.46 STC00838 EZZ9298I GLOBALTCPIPDATA - ADCD.Z113S.TCPPARMS(TCPDATA)
08.11.46 STC00838 EZZ9298I DEFAULTIPNODES - ADCD.Z113S.TCPPARMS(IPNODES)
08.11.46 STC00838 EZZ9298I GLOBALIPNODES - ADCD.Z113S.TCPPARMS(IPNODES)
08.11.46 STC00838 EZZ9304I NOCOMMONSEARCH
08.11.46 STC00838 EZZ9304I CACHE
08.11.46 STC00838 EZZ9298I CACHESIZE - 200M
08.11.46 STC00838 EZZ9298I MAXTTL - 2147483647
08.11.46 STC00838 EZZ9298I UNRESPONSIVETHRESHOLD - 25
08.11.47 STC00838 EZZ9291I RESOLVER INITIALIZATION COMPLETE
While doing TSO hometest, session got stuck, and console shows me :
*EZZ9308E UNRESPONSIVE NAME SERVER DETECTED AT IP ADDRESS 192.168.0.1
EZZ9310I NAME SERVER 192.168.0.1 724
TOTAL NUMBER OF QUERIES SENT 1
TOTAL NUMBER OF FAILURES 1
PERCENTAGE 100%
EZZ9309I NAME SERVER IS NOW RESPONSIVE AT IP ADDRESS 192.168.0.1
EZZ9310I NAME SERVER 192.168.0.1 726
TOTAL NUMBER OF QUERIES SENT 0
TOTAL NUMBER OF FAILURES 0
PERCENTAGE 0%
The problem might be, is that I cannot even pin 192.168.0.1 from Hercules. I can only ping 192.168.0.122 ( windows ). Therefore, I think some windows routing might need to be done.
The configuration of the globaltcpipdata, ipnodes etc have been done as instructed.
I propose we stop the conversation on this topic, as in this place is a little bit off subject.
Dragos