RE: Re: quit files

Hi Paul
 

Well, the same of course ;-). However with differing statistics. With all three sets of binaries it may well be that a whole series of runs comes out fine, and that all fail. So, our amount of samples is apparently far below statistical significance. Too bad, but not worthwhile to be pursued further at this point in time. I think the three major clues we got 

 - it is an old problem
 - it is not TCAM related
 - it is reliably reproducible (most of the time)
 

 suffice to go back into an orderly mode of analysis. I'll dive into this again now, hoping for more luck than during the last try in May. It may take quite a while until I come back with results.
 

 Until then you might still consider disabling the critical devices as a workaround. Simply create a file named tk4-.parm in tk4-\local_conf and enter these two lines into this file:
 

 @ECHO OFF
 SET REP101A=specific
 

 Your "quit" problem will definitely be gone then.
 

 Cheers
 Jürgen

---In [email protected], <kerravon86@...> wrote :

 ---In [email protected] mailto:[email protected], <winkelmann@...> wrote :
 
 > Now I'm of course _very_ interested to see how
 > this compares to the original TK4- Hercules binaries...
 
 I have posted those results now.
 
 I'm curious as to what happens on YOUR
 system when you type "quit" after the IPL
 is completed.
 
 BFN. Paul.