Re: Re: Help with IPL problem

"Michael Wojtukiewicz [email protected] [H390-MVS]" <[email protected]> Mon, 16 Sep 2019 14:32:48 -0400

Newsgroups	gmane.comp.emulators.hercules390.mvs
Message-ID	<[email protected]>

*HHC00416E 0:5003 CKD file c:/hdasd/uzosf1: control unit 3390-6 not 
found in dasd table                                  HHC01463E 0:5003 
device initialization failed *

On 9/16/2019 1:36 PM, rixhawg-/[email protected] [H390-MVS] wrote:
>
> Michael,
>
>
> I'm not sure if this is the cure for your issue, but when I looked at 
> your .cnf file, I noticed that you did not specify a control unit for 
> your dasd.  This could explain why during your IPL that it cannot vary 
> on the dasd due to invalid control unit model.  In my .cnf file for my 
> z/OS 1.13 system, I have them defined as cu=3990-6.  See below for an 
> example:
>
> 1000    3390    "E:/z-os 1.13/dasd/mmsa/z23res.3390-27.cckd" cu=3990-6
>
> Try adding the cu=3990-6 to your dasd definitions and see if that works.
>
> Rick
> 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus