Re: Fullscreen application Specs

--- In [email protected], "Rocky" <rocsystems@...> wrote:
>
> Fran  ALL
>  
> I really do appreciate your testing - > you wrote:
> 
> ------>I get a little disoriented with the screen position after these  prefix commands.  I'm not sure what to expect but it is different than Xedit.
> 
>    
> About the screen jumping around  after inserts and deletes and the setting of the CURSOR position I agree with you that it is very messy.
> I get confused also
>  
> I would like someone to define a set of SPECS and I will do it - Not a big  issue and it can be done in a day. Just need to know what we expect the first line to be after an INSERT,  COPY. MOVE and DELETE and the same for MM  CC DD
>  
Rocky,
I won't repeat my compliments for your execellent job;-)

IMHO after every MM,M,CC,C etc. the *FIRST* line on the screen should remain in its position (As it does in XEDIT;-)

I looked a little into your 'terminal stuck problem', and after some DIAL into another Virtual Machine and then disconnecting and reconnecting the TN3270 session it appears that VM/370 doesn't detect when a dialed terminal goes off.

If  you disconnect and reconnect a TN3270 session within your application the screen you were working on is resent without dropping the DIALED GRAF and with a message 'KEY PRESSED INVALID'.

Regards.

Paul